Don't forget to pickup a set of these color cable ties.
They compliment the pluggable cable management box nicely.
Wall mount to save space. Have a clutter free floor and a clutter free desktop.
Quick and hassle free installation. Less than one minute installation with a single screwdriver.
Minimize overall cost. With a built-in surge protector you have one less thing to buy.
Currently, white is the only color option for the box. Depending on demand we may have other color(s) in the future. Feel free to provide any suggestion via the contact us form below.
Depending on demand we may have other colors in the future for the transparent lightning bolt. Feel free to provide any suggestion via the contact us form below.
Currently, we only have one size. Depending on demand we may have a smaller pluggable cable management box in the future. Feel free to provide any suggestion via the contact us form below.
You can be creative and remove the surge protector then use the anchors/screws to mount the box anywhere you like. Also, you can use them to further strengthen the box to the wall if you don't feel comfortable without them.
It is not a requirement but if you test it out you will notice that it fits better. What is important is the tightening of the 2 inch middle screw (included with every box) or else the whole cable box might fall off in time.
When removing the outlet plate, turn off the power to your wall outlet before you start.
Your wall outlet is up-side-down because it was installed incorrectly. You can turn it back to the correct direction with just a screw driver. Safety first, turn off the power to your wall outlet before you start.
Another option is to turn the Pluggable Cable Management Box's surge protector up-side-down. You will need a screw driver to do that.
We'd only listed countries that use "Type B" outlet. If your country is not listed and you would like to buy a large quantity without the built-in "Type B" surge protector feel free to contact us with the form below.
Load all your adapters and cables before installing into a standard wall outlet.
Remove the outlet cover plate. Plug the box in. Tighten the middle screw. Close the cover.
To open, the bottom needs to be snapped off first. To close, the top needs to be fitted first and then snap the bottom in.
Model Number: X1
Number of Outlets: 6 outlets
Sets of Plugs: 2 full sets (only bottom set active)
Surge Protection: 1080 Joules
AC Rating: 125V/15A/1875W
Item Height: 5.2 inches
Item Width: 3.6 inches
Item Thickness: 1.6 inches
Item Weight: 0.49 pound
Certification: ETL (same UL standards)
Instruction Lights: green protected LED light and red fault LED light
In keeping with the latest standards there can only be one set of active plugs. In most cases wall mounted surge protectors are manufactured with a single set of plugs. This can cause instability. We have two sets of plugs to provide maximum strength or 'grip' to attach the cable management box into the wall. The bottom set is active but the top set is inactive. It works the same as any UL/ETL certified wall mount surge protector.
Yes and no. You can use your own surge protector but it cannot be attached to the box the same way as our built-in surge protector. You can removed the built-in surge protector and throw in a corded one. The box will need to be mounted to the wall using the included anchor/screw sets.
The Pluggable Cable Management Box was not designed for universal in-wall surge protector fitting.
